日本語のみで絞り込む
This document describes the passive-interface command, which can be used to control the advertisement of routing information.
The Default Passive Interfaces feature simplifies the configuration of distribution devices by allowing all interfaces to be set as passive by default.
passive-interface command · advertises the defined network in RIP. · activates RIP on the interfaces whose addresses fall within the specified classful networks.
Passive Interfaces The passive-interface command tells an interface to listen to RIP or IGRP routes but not to advertise them.
OSPF interfaces can be made passive with the passive-interface command. This prevents them from sending OSPF hello packets.
2019/8/8 -The passive interfaces are used for routing protocols, typically to not advertise the routes to the devices out that interface (typically a LAN) ...
The RIP passive interface command prevents RIP updates from being sent on the interface. This lesson explains the configuration.
2022/10/22 -EIGRP Passive Interface is enabled, and the router begins to originate Hello packets and process incoming EIGRP packets on all interfaces that ...
OSPF is a link-state routing protocol that creates and keeps neighbor relationships by sharing routing updates with other OSPF routers.
2022/11/4 -Configuring an interface as a passive interface in and OSPF domain causes OSPF to stop sending Hellos on that specified interface. OSPF will ...
A.何かいろいろとおかしいですね。どこから指摘していいのか… c892ではVlan500がPassiveになっていますね。 これだとc9300とRIP喋れないと思います。 ただ、c892ではRI...
Q.CiscoのICND2に向けてCCENTの復習をしています。 そこで質問があります。画像のようなものをPacket Tracerで作成しました。 PC-1グループとPC-2グループからPC-3グ...
A.LAB-Bは適性に設定されている事を前提にお話しますが。 s0/0/0 のネットワークアドレスって 172.16.0.0で良いんですか? 画像が粗いので見間違いかもしれませんが 私の見間違い...
Q.CCNP向けの問題で、どうしてもわからない問題があります。 インターフェイスの帯域幅の違いをOSPFコストへ反映させるコマンドは何か。 1.bandwidth 2.ip ospf cost 3....
A.http://www.n-study.com/network/2005/03/cisco_ospf.html からの情報抜粋です。どぞ。 OSPFコストを変更するには、次の3つのコマンドがあり...