Cisco switches have traditionally supported two encapsulation methods for trunks: ISL and dot1q . Newer switches no longer support ISL, so there is only one ...
2024/6/7 -This document describes the difference of IEEE 802.1Q (dot1q) trunking between Cisco Catalyst switches that run Cisco IOS® Software.
2020/7/4 -The switchport trunk encapsulation dot1q command tells the switch that the interface should use IEEE 802.1Q encapsulation on the frames when the interface is ...
2019/11/21 -I am trying to trunk VLANs on one interface but trunk encapsulation dot1q is showing invalid command on Cisco Catalyst 2960.
I have created Vlans and in the Multilayer switch when I tried giving "switchport trunk encapsulation dot1q" it's not accepting.
2024/1/22 -“switchport mode trunk” is all that is needed to enable vlan trunking 0on the port. It will use native vlan of 1 by default and allow any configured vlan.
Trunks are required to carry VLAN traffic from one switch to another. This lesson will demonstrate how to configure a trunk between Cisco Catalyst switches.
This instructional video will provide a comprehensive guide on configuring Inter-Vlan using Cisco Packet Tracer.
YouTubeNetwork of Networks
Learn how to configure an ISL and 802.1q trunk link between two or more Cisco switches to pass all vlan traffic between Cisco switches.
2018/4/25 -Command: Switchport Trunk Encapsulation dot1q. Use: Enables dot1q trunking encapsulation on the interface.