日本語のみで絞り込む
OSPF uses the hello and dead interval to check if a remote neighbor is still alive. This lesson explains how to tune these timers.
Sets the interval after which a neighbor is declared dead if no hello packet is received on the OSPF interface. The no form of this command ...
2022/11/18 -OSPF hello and dead timers ... There are different Hello and Dead timers for non-broadcast network types and broadcast and point-to-point network ...
2023/8/3 -The dead interval specifies the length of time, in seconds, that the routing device waits before declaring that a neighbor is unavailable. This ...
2021/12/27 -This command configures the 'dead interval' for the OSPF interface. The dead interval specifies the time (in seconds) that the router should ...
2016/2/23 -OSPF fast hello packets are achieved by using the ip ospf dead-interval command. The dead interval is set to 1 second, and the hello-multiplier ...
The OSPF Dead interval is announced in OSPF hello packets. It is the amount of time during which the router waits to receive at least one hello packet from a ...
ospf timer dead seconds. By default: The dead interval on P2P and broadcast interfaces is 40 seconds. The dead interval on P2MP and NBMA interfaces is 120 ...
ip ospf dead-interval. Configures the neighbor dead interval, which is the number of seconds that a neighbor router waits for a hello packet from the device ...
The dead interval specifies the length of time, in seconds, that the routing device waits before declaring that a neighboring routing device is unavailable.
Q.OSPFプロトコルの迂回動作について OSPFは障害時にイベントトリガーアップデートにより、 瞬時に経路迂回を行うと認識しています。 ただ、ケースによってはネイバーのDead Intervalの...
A.OSPFから見るインターフェースって何かわかりますか？ポートの事ではないですよ。なので、ケーブルを抜いてポートダウンさせても、イベントトリガーは動作するとは言えません。OSPFは、IPが割り当て...