日本語のみで絞り込む
Spanning-Tree Protocol (STP) prevents loops from being formed when switches or bridges are interconnected via multiple paths. Spanning-Tree Protocol ...
STP calculates the path cost based on the media speed (bandwidth) of the links between switches and the port cost of each port forwarding frame. Spanning tree ...
2018/12/13 -This article aims to show you how to configure STP on Sx300, Sx350, SG350X, Sx500, Sx550X Series Switches through the CLI.
This lesson is an introduction to spanning-tree. You will learn how spanning-tree works and how you can verify the spanning-tree config on Cisco switches.
2008/5/28 -STP Overview. STP is a Layer 2 link management protocol that provides path redundancy while preventing loops in the network. For a Layer 2 ...
2017/12/1 -Spanning Tree Configuration (3.3). In this section, you will learn how to implement PVST+ and Rapid PVST+ in a switched LAN environment.
2023/10/25 -Spanning tree protocol (STP) (IEEE 802.1D) is predominantly used to prevent layer 2 loops and broadcast storms and is also used for network ...
Learning or brushing up on Spanning Tree? This video can help. More Spanning Tree Protocol (STP) content from my channel here: ...
YouTube-Keith Barker - The OG of IT
Configure a spanning-tree mode on STP ports on the switch. • Select pvst to enable PVST+. • Select mst to enable MSTP (and RSTP). For more configuration steps, ...
In this edition of Cisco Tech Talk, I'll explain how Spanning Tree Protocol (STP) works and how it is configured with three or more Cisco ...
YouTube-Cisco
Q.下記configの設定のみでcisco2960-8のstpが有効になっているかわかりますか？ spanning-tree mode rapid-pvst spanning-tree exten...
A.no spannig-tree vlan xx の設定がなければ有効になっていると言えます。 extend system-idは有効/無効に関係ありません。
A.常識かどうかは別にしてSTPを組むのとEtherChannel(LACP)は別物です。 EtherChannelは帯域が1Gで足りない場合などに使います。 ★補足 どうもです。EtherCh...
Q.Ciscoのレイヤー２スイッチで冗長化する場合、STPを使用するとL2スイッチが壊れると自動的に切り替わると思ってもよろしいでしょうか？ レイヤー２スイッチをSTPを使用して、冗長化した場合、ホ...
A.おっしゃるとおりです。 他に、レイヤ2スイッチ間のケーブル障害時などにも切り替わります。