日本語のみで絞り込む
cdp holdtime. Specifies the amount of time the receiving device should hold a CDP packet from your router before discarding it. ; show cdp. Displays global CDP ...
2010/5/25 -Sets the time that CDP holds onto neighbor information before removing it. The range is from 10 to 255 seconds. The default is 180 seconds. cdp ...
2021/11/20 -CDP Holdtime is set to 180 seconds by default. You can use the global commands cdp timer and cdp holdtime to change the default time ...
The CDP hold time must be set to a higher number of seconds than the time between CDP transmissions, which is set using the cdp timer command.
CDP holdtime. 180 seconds. Getting CDP Timer and Holdtime Information. The following command shows the CDP timer which is how often CDP packets are sent and the ...
The default hold time value is 180 seconds, but you can enter values ranging from 10 seconds to 255 seconds. If an IP address is ...
Manually sets the CDP holdtime (dead timer) timer to the specified time in seconds. This command is configured in global configuration mode. Lab Prerequisites.
2023/11/23 -The local interface is the port on which CDP enables the device to receive the CDP packets. Hold time means the router's remaining amount of ...
CDP Holdtime: CDP record holding time (120 seconds by default). To configure ... Time is mentioned as seconds. Switch(config)# cdp timer 50. Switch(config)# cdp ...
CDP: CDP, short for Cisco Discovery Protocol runs over Layer 2 (the data link ... The following command sets the cdp timer, holdtime. R1>enable. R1#configure ...
Q.Ciscoの「cdp neighbors detail」についての質問です。 ルーターabcdeのインターフェース状況は下記の通りです。 interface FastEthernet0 ip...
A.>> Interface: FastEthernet0, Port ID (outgoing port): FastEthernet0 この内容を見る限り、FastEthernet0