Yahoo! JAPAN

Low speed (LS) rate of 1.5 Mbit/s is defined by USB 1.0. · Full speed (FS) rate of 12 Mbit/s is the basic USB signaling rate defined by USB 1.0. · High speed (HS) ...

2016/4/24 -FS stands for "full-speed", 12 Mb/s (USB 1.0/1.1). HS stands for "high-speed", 480 Mb/s (USB 2.0). There is another higher speed in use, "Super ...

2021/9/11 -HS stands for "High Speed" and refers to a mode of operation that is supported by some USB OTG (On-The-Go) devices. OTG is a technology that ...

The STM32H7 microcontroller embeds two instances of a. USB HS peripheral (OTG_HS1 and OTG_HS2). Both support Full-Speed communication and OTG mode but only.

A 'Dual-Role' USB On-The-Go IP Core that operates as both an USB peripheral or as an USB OTG host in a point-to-point communications with another USB device ...

This arrangement is able to reliably receive data sent at 480 Mb/s. In fact the 45 Ohm resistors are provided by the Full Speed / Low Speed driver, at each end ...

2018/5/3 -USB 2.0 includes LS, FS, and HS modes, and USB 3.x has SS ... This means that the USB host is not HS, and the link proceeds as a FS link.

2021/9/20 -If the HS Chirp sequence fails, both the host and device/hub should stay and operate in Full-Speed mode. Common reasons for failures include:.

2021/11/11 -Unlike the competitors with only FS USB PHY, the dual-USB parts contain both. FS and HS on-chip PHY, which can greatly reduce design complexity.

It appears, but is not clear from the data sheets, that the STM32F7 and some STM32F4's have two separate USB controllers a FS one and a HS one. Assuming ...