Yahoo! JAPAN

2007/5/6 -The formula for obtaining default 32-bit port costs is to divide the bandwidth of the port by 200,000,000. Table 7-2 shows the default port cost ...

2023/3/15 -In a Spanning Tree instance, the port cost is used to determine the path to the root switch. The lower the cost, the more preferred the path.

Spanning tree uses cost to determine the shortest path to the root bridge. The slower the interface, the higher the cost is. The path with the lowest cost will ...

2020/2/16 -yes. The root path cost is only the cost of each switch's root port. So the individual costs aren't considered. If you want to make SW3's port ...

I'm practicing spanning-tree with two 2950 switches (Ver 12.1). I have 3 trunks and 3 vlans. I try to change the cost of the interface (for the 3 vlans) and ...

2017/12/1 -Designated ports are selected on a per-segment basis, based on the cost of each port on either side of the segment and the total cost calculated ...

2016/12/26 -First of all, the STP cost can be calculated in one of two ways: short method or the long method. The short method uses a 16-bit number and is ...

Configure the Spanning-Tree Path Cost. When a loop occurs in the network topology, STP uses path cost to determine the spanning-tree states of the ports.

Solved: Hi, I'm quite aware of Spanning-tree, it's port states, port roles and so forth. But i'm not sure about whether i should configure port cost or port ...