Yahoo! JAPAN

2020/2/15 -This article provides instructions on how to configure an interface VLAN as an access or trunk port on your switch through the Command Line ...

access vlan command. Step 4 switch(config-if)# switchport access vlan vlan ... To specify that only certain VLANs are allowed on the specified trunk, use the ...

The switchport access vlan command assigns a Layer 2 interface on a Cisco IOS device to the specified VLAN. This command only takes effect for interfaces that ...

It statically disables trunking on the port, which defaults to dynamic trunk. IOW, if you plug a device that has no trunking capabilities, the ...

2023/8/29 -switchport access vlan X is the configuration for when the port is in access-mode. The config can exist regardless of the actual, or configured ...

The switchport mode command allows us to configure the trunking operational mode on a Layer 2 interface on a Cisco IOS device. By entering the command ...

An access port can have only one VLAN configured on the interface; it can carry traffic for only one VLAN. · A trunk port can have more VLANs configured on the ...

2020/9/10 -Using the “Switchport mode access” command forces the port to be an access port while and any device plugged into this port will only be able to ...

2020/2/24 -1. Configure the new interface to be in access mode using the "switchport mode access" command. · 2. Copy the running configuration to a text ...

The switchport mode access command sets the port as an access port, and the switchport access vlan <#> command designates the port as a member of VLAN 10. Some ...