Yahoo! JAPAN

There are two types of switchports: trunk or access. A access port is typically for a switch to host connection and this port is assigned to only one VLAN.

2023/10/5 -You can verify the switchport status of an interface by entering the show running-config privileged EXEC command. Cisco Catalyst 6500 and 6000 ...

2015/6/9 -Any switch port can belong to a VLAN, and unicast, broadcast, and multicast packets are forwarded and flooded only to end stations in the VLAN.

2020/2/15 -A switch port can belong to a VLAN. Unicast, broadcast, and multicast packets are forwarded and flooded out ports in the same VLAN. VLANs can ...

switchport nonegotiate: Prevents the interface from generating DTP frames. You can use this command only when the interface switchport mode is access or trunk.

Trunks are required to carry VLAN traffic from one switch to another. This lesson will demonstrate how to configure a trunk between Cisco Catalyst switches.

2020/2/24 -Hi All,. I am using Cisco Packet Tracer. This is configuration on switch 2960-24TT. interface FastEthernet0/1. switchport mode access.

2020/9/10 -Access ports are part of only one VLAN and normally used for terminating end devices likes PC, Laptop and printer. Default Behavior (Cisco ...

The switchport mode command allows us to configure the trunking operational mode on a Layer 2 interface on a Cisco IOS device. By entering the command ...

Switchport host command makes: the port an access port, sets the Spanning Tree portfast feature, disables port-channel. switch# configure terminal switch(config)# ...