日本語のみで絞り込む
For MD5 authentication, you need different commands. First, use ip ospf message-digest-key X md5 to specify the key number and password. It doesn't matter which ...
2023/8/21 -You can also use the ip ospf authentication message-digest command under the interface to configure MD5 authentication for the specific ...
ip ospf message-digest-key 1 md5 7 12232... This line is from a running config. The typr is 7 as the key is stored in the config in an "encrypted" form.
Specifies the md5 key ID. Range: 1 to 255. {ciphertext | plaintext}. Selects the md5 key format. <KEY>.
Enables authentication and specifies the type of authentication to be used on the OSPF interface, either password or message digest. message-digest-key. Use ...
The ip ospf message-digest-key command accepts spaces but omits those at the start of the password. The password should not exceed 16 characters and can include ...
2004/5/10 -ip ospf message-digest-key md5. Enables MD5 authentication and configures the key ID and password combination for an interface.
Information. Enable Open Shortest Path First (OSPF) Message Digest 5 (MD5) authentication. Rationale: This is part of the OSPF authentication setup ...
Sets the virtual link md5 message digest authentication key. If the md5 key is given in ciphertext, it will be decrypted and applied to the protocol.
This is done by using the area AREA_ID authentication [message-digest] command under the OSPF configuration mode. If you omit the message-digest keyword, a ...