日本語のみで絞り込む
To debug all HSRP error events, use the following command: Router2# debug standby errors. The events keyword will display information about HSRP events:
Standard HSRP Debugging. In Cisco IOS enable the HSRP debug capability with the command debug standby. This information is useful where problems are ...
2017/7/10 -To disable debugging output, use the no form of this command. debug standby [terse]. no debug standby [terse]. Syntax Description. terse.
2019/1/24 -When the screen is turned off, the Modern Standby session starts and the system goes through multiple phases to move into a low-power state.
The router will actively forward packets from clients and send hello messages. We can see all these steps with a debug command. Let's shut the VLAN 1 interfaces ...
Posted on July 03, 2015 at 10:59 Hello, Can we Debug in Standby low power mode ? and how ? I use STM32F103, STLink V2, GCC ARM. Thanks :) #debug-mode.
2023/4/24 -The other routers are in standby mode, ready to take over if the active router fails. ... Debugging HSRP state transitions can be done using the “ ...
2022/3/24 -Hot Standby Router Protocol (HSRP) is a Cisco-proprietary First Hop Redundancy Protocol that allows physical gateways that are configured as ...
Q1: It is given in the datasheet that when VDD_OTP is applied, PMIC will be pushed to debug mode and all regulator outputs are disabled. But ...
2023/4/27 -Standby is the keyword in Hot Standby Router Protocol (HSRP). ... " With the debug command, it will be "# debug standby." Only one of ...