2017/11/11 -To avoid a single point of failure, you can configure several candidate BSRs in a PIM domain. A BSR is elected among the candidate BSRs ...
The BSR mechanism interoperates with Auto-RP on Cisco routers. To avoid a single point of failure, you can configure several candidate BSRs in a PIM domain. A ...
Auto-RP is a Cisco proprietary protocol that uses two different roles: Candidate RP; Mapping Agent. The candidate RP is a router that announces itself that it ...
2013/2/25 -you can use “ip pim rp-candidate ” command to define candidate RPs. ... ip pim rp-candidate 10.12.0.20 group-list 239.0.0.0/8 (is this cmd needed ...
2009/4/7 -To set up a candidate RP in Cisco IOS, use the command ip pim rp ... The command to set up a BSR in Cisco IOS is ip pim bsr-candidate ...
Candidate BSR: this is the router that collects information from all available RPs in the network and advertises is throughout the network. It's function is ...
Every PIM router elects an RP for the group from the RP-Set. Here, since the priorities are same for every C-RP (defined in ip pim rp-candidate command), a hash ...
Sets the local interface as a candidate BSR. This command operates similar to the command ip pim bsr-candidate - value. This command is applicable only in VLAN ...
2023/5/23 -ip pim bsr-candidate · A BSR is a PIM router within the PIM domain through which dynamic RP selection is implemented. · Command parameters specify ...
2013/2/1 -If you configure multiple RPs & all of them acting as candidate-RP for same multicast group range, highest IP router will be selected as RP.