日本語のみで絞り込む
To configure the inline power administrative mode, use the power inline limit-mode command in switch configuration mode. To restore the default configuration, ...
2015/3/21 -Enter configuration commands, one per line. End with CNTL/Z. Switch(config)# power inline consumption default 5000. Switch(config)# end
Specifies the physical port to be configured, and enters interface configuration mode. 4, power inline {auto [max max-wattage] | never | ...
The auto keyword sets the interface to automatically detect and supply power to the powered device. This is the default configuration. The static keyword sets ...
You should use power inline consumption default wattage command to manually set the power level for a port only in situations where CDP/LLDP power negotiations ...
2009/2/2 -Make sure your power inline default is set as 15400 . Maybe the default is currently set as 7000. conf t power inline consumption default 15400 ...
The easiest option is to set the switch to auto configuration so that it will work as described above. To do that, type “switch(config-if)# power inline auto”.
PoE configuration: ; show power detail, Displays the PoE state in detail ; [no] power inline consumption default, Sets the PoE consumption (in milliwatts) of all ...
2022/4/14 -The show power inline [interface | consumption default | module switch-number] command is used to display the PoE status for the specified PoE ...
2024/5/5 -To enable Power over Ethernet (PoE) on a Cisco switch, you can use the following command: "power inline {auto | static | never}"