日本語のみで絞り込む
As I said earlier that the port priority determines which ports you should be using when you have more than 8 links connectd/bundled using etherchannel.
The values for the priority range from 0 to 65535. The lower the value, the higher the system priority. The switch with the lower system priority value ...
2024/3/4 -LACP system priorities determine the sequence in which devices at two ends of an Eth-Trunk select active interfaces to join a LAG.
LACP Port Priority ... Hello Guys,. I have a small doubt about Lacp Port priorit values, as some doc says it ranges from 0 - 65535, but some says about 1 - 65535.
Note - Before configuring the LACP port priority, consider that the extreme-ethernet port, 0/3, is the standby port in switches A and B. The maximum number of ...
Parameters. system-priority: Specifies the system LACP priority in the range of 0 to 65535. The smaller the value, the higher the system LACP priority.
2023/8/7 -In LACP mode, LACP interface priorities are set to prioritize interfaces of the same device. Interfaces with higher priorities are selected as ...
Specifies a system priority value. Range: 0 to 65535. Examples. Setting a Link Aggregation Control Protocol (LACP) system priority to 100 ...
2021/4/5 -LACP interface priority enables the master switch to choose which member interfaces are active in a port channel when there are more member ...
Sets an LACP port priority value for the member interface of the LAG. The no form of this command reverts the LACP port priority to the default, ...