日本語のみで絞り込む
This ip policy route-map command disables fast switching of all packets arriving ... ip policy route-map map-tag. 6. exit. 7. route-map map-tag [permit | deny] ...
13.3 (R3). Last but not least, let's activate it: R1(config)#interface GigabitEthernet 0/1 R1(config-if)#ip policy route-map PBR_H1. Let's see if it works ...
2019/4/4 -Enter the configuration for interface fa0/0. Apply the route-map, followed by ip policy route-map POLICY. This directs the policy of that entry ...
4.4. access-list 1 permit ip 2.2.2.2 access list 2 permit ip 8.8.8.8 ! interface boostedethernet 3/1 ip policy route-map Massachusetts ! route-map ...
255.0 Router(config-if)# ip policy route-map Engineers Router(config-if)# ip route-cache policy Router(config-if)# exit Router(config)# route-map Engineers ...
2021/4/15 -ip policy route-map PBR. With that, PBR is now effective for any traffic that's coming in on that serial 1/1.478 sub-interface. Say we wanted ...
2005/12/9 -Policy routing is defined with the command ip policy route-map. The command is configured on an interface and affects incoming packets only.
R1(config-subif)# ip policy route-map PBR-grandmetric. To check if the policy is attached to specific interface: R1# show ip policy. Interface Route map. Fa0 ...
2024/4/7 -Now we need to enter the route map name that we created which is CLIENT-TO-INET. R1(config-if)#ip policy route-map CLIENT-TO-INET. Now our ...
ip policy route-map. Enables policy-based routing (PBR). Syntax. ip policy route-map map-name. no ip policy route-map map-name. Command Default.
Q.PBRの設定について ルーター1(R1)のインターフェースに対して、PBRを設定する際に 以下のような設定例がテキストに記載されていました。 5行目:R1(config)#route-map ...
A.PBRでは仰るとおり、空打ちは必要なかったように思います。 しかしながらBGPの経路制御で使用する場合などは、 最後に「route-map pbr permit 20」のような行を、 入れておか