Yahoo! JAPAN

2022/6/20 -Use [select disk #] or [sel dis #] to open specific drive, then run [detail disk] or [det dis] to show details.

The most basic command in dealing with SATA drives is the IDENTIFY command. It is used to read the current settings of the drive under test. Define a 12-byte ...

2022/9/1 -The IDENTIFY_DEVICE_DATA structure contains the data retrieved by an ATA identify device data command (0xEC).Note The ATA port driver and ...

There are six main reasons why a system BIOS will not detect the presence of an internal hard drive. Here is a list of them. They are not in any particular ...

DESCRIPTION. This utility sends either an ATA IDENTIFY DEVICE command or an ATA IDENTIFY PACKET DEVICE command to DEVICE and outputs the response. The devices ...

With SATA product authentication, you can always be sure that the product you have obtained is an original in unique SATA top quality. Check the packaging and ...

The Identify Device command (command code ECH) transfers information about the drive to the host following power up. The data is organized as a single 512-byte ...

2022/11/4 -I've narrowed the possibilities down to the IDENTIFY DEVICE command that SATA drives send after power on, since the response from this command ...

2020/1/20 -Check your motherboard. Near the SATA ports it should say “SATA 6G” or “SATA 3G”. SATA 6G = SATA 3. SATA 3G = SATA 2.