約41,700件1ページ目

日本語のみで絞り込む

条件を指定して検索しています。すべての条件を解除する

  • 最終更新日:6か月以内
  • 2024/3/11 -h> #include <dt-bindings/leds/common.h> led-controller { compatible = "gpio-leds"; led-0 { function = LED_FUNCTION_STATUS; linux,default-trigger = "heartbeat ...

    2024/1/31 -The internal LED now blinks in heartbeat mode but the external LED does not light. I've tested the external LED with 3.3v and it does work. Have I done ...

    2024/4/4 -Let's configure the GPIO as a Linux heartbeat for example: Target (Linux) . echo "heartbeat" > /sys/class/leds/red\:disk/trigger. The heartbeat trigger can ...

    他サイトを含む一部でポイント、送料、クーポン等の情報が欠けている場合があります。またポイント等の付与は税抜価格が対象のサイトがあり、付与には条件・上限があります。-

    2024/4/11 -The agent process ( omsagent ) wasn't successfully started, so there isn't any heartbeat data available. Run the following command that uses the ps and grep ...

    2024/2/7 -... LED state coming from the pattern (on for activity, or on for the heartbeat) and the drive applied to the SoC pin (on->high/off->low or on->low/off->high).

    2024/1/2 -The KY-039 heartbeat sensor module has an IR LED, a photosensitive diode and a resistor on-board. The output of the module is an analog voltage that.

    2024/1/30 -45. I already completed learning vi after knowing this issue. Now i will use vi directly in linux shells. And its vi or vim ? because both works on linux shell.

    2024/3/25 -** UPDATE: I noticed when you send the set_time/heartbeat too often it will slow down. if i leave the heartbeat to hit every 1 second, and send the screen ...

    2024/1/22 -For this project, we will disable the heartbeat LED. Save the changes made to the file using Ctrl + X then Y and Enter.

    2024/3/17 -The Heartbeat LED shows an error blink pattern for the following conditions: 1 blink - Normal operation. 2 blinks - Not used. 3 blinks -System error. 4 blinks ...