動画検索
関連広告
検索結果
Fix PCB board method one: Clean the contacts
Common components on the PCB
Method three: PCB swap
The correct donor board is found!
What is Hard Drive PCB firmware(BIOS) transfer, and why?
Quick data recovery tips
Cool down a hard drive by fan
How do we cool down chips under the PCB
Common disk assembly problemes
The procedure of data recovery
Prepare a screwdriver kit, PC USB terminal and a piece of paper
Connect the drive to the PC-3000 diagnostic port
Plug the PC-SEAG adapter through the PC USB terminal
Open the Seagate F3 utility without powering the drive
Power on the drive and check the terminal output
Re-power the drive to get the terminal output again
Select the profile for drive's resources
Isolate the spindle contacts with a piece of paper
Full Drive ID is shown now
Verifying that the sectors are readable
Remove the lid from the hard drive
Put a screw inside the bearing and • place the tool on the actuator arm base.
The construction of the tool enables the snouts to lift heads by a relatively small force.
While unscrewing this screw, hold the tool outside of the platter area with your other hand.
Gently push the tool with heads over the platter and then remove the security pin
Push the back side of the head arm to slide the head off the platter
Since the heads are not secured with a pin, make sure that they don't slide off the tool.
Tighten the screw that's holding the tool and head arm connected, just in case it got loosen up during the manipulation.
Use the assisting tool to make counter-force.
Put the magnet to its place and then close the lid.