動画検索
関連広告
検索結果
65 TON POWER UNIT
HYDRAULIC PUMP
Apply Swage grease to the bend, die block and the outside of each Swage die. Spread it evenly with your fingers.
With the die faceplate off, slide the die into the grooved area of the head ensuring it sits correctly in the bottom faceplate.
Install the top faceplate to lock the die into the head assembly using a Philips head screwdriver. Repeat steps for the die block assembly
Attach the die block to the power unit by holding the unlock button on the side of the die block. Slide the pin into the bottom and release the lock
Slide the head assembly on to the power unit and ensure the rollers on the die block roll into place.
Remove safety caps from the bottom of the power unit and hose fitting. Insert hose fitting into the power unit and tighten to ensure a tight seal.
Used Head Assembly with Dirty Dies During Swaging - Dies can Collect Dirt, Debris and Metal Shavings
Clean - All Head Assembly Parts Use a Parts Washer Of Available or Hot Soap & Water Solution to Clean Parts
Re-Apply Swage Lube Use Swage Lube in Inner Face of Lower Die Block and Upper Yolk
Re Apply Swage Lube Upper Yoke Use Swage Lube on Inner Face of Fillor Die (Custom) and Back of Dies
Re Assemble Head Assembly - Lower Die Block Using Screw Driver (Philips Head Bit)
Head Assembly Cleaning Complete! Ready to Swage!