動画検索
関連広告
検索結果
Drill both screws into the marks you made.
Mount the pocket onto the screws.
Nest the second pocket into the first, using the acrylic slats that are on the back of each pocket to fit into each other.
Again, mark the points where the screws will go.
Drill both screws into the points you marked.
Mount the second pocket onto these screws, while also nesting it inside of the first pocket.
Drill the screws....
Finally, mount the third and final pocket...
I started with a box of Uncutor "Full Tab" file folders.
Regular file folders have this notch out that I wanted to avoid.
Using a round plate as a guide, I cut one corner off of a folder.
Using a pencil and my template, I marked a cut line on each folder.
I cut the tab off the folder to make the front and back even.
Then I cut off the front corner.
Now the top is done (except for erasing any pencil marks.)
I used a piece of clear packing tape to seal the bottom.
I use 3M File Tabs to label my permanent folders.
I use these vertical file folders in my vertical wall file holders.