The D barcode is scanned into the data

PrintFlow Manager Optional

PrintFlow Manager 1 Optional

Bad material will be extracted on the rewinder/doctor machine

Reciprocating Saw

How does AVT work?

New 2kg hammers

Reduced vibration levels

Piston cylinder and Counter weight move in opposite directions each other to offset vibration.

Main handle absorbs the vibration with both Vibration control spring and Rubber ring.

Vibration-absorbing housing with a spring-loaded handle and housing which moves independently of the motor and hammer mechanism, effectively isolating vibration away from the user.

Integrated damper spring at the base of the impact bolt engineered to absorb impact vibrations from the drill bit.

Air-actuated counterbalance system that directs air pressure from the crank and barrel cylinder into the counterbalance chamber to push counterweight pistons in the opposite direction of the hammer mechanism.

Counter Weight moves towards the opposite direction against Piston.

This effectively removes vibration and realizes Super Low Vibration.

Motor/Transmission section.

This is the Vibration Absorbing Housing. The four Damper Springs absorb vibration.

Vibration that tries to reach the hands, gets structurally reduced.

Clean and remove any damage to the pipe

Place the valve on the pipe and loosely secure in position

Pressure Test

End Milling

Partially lower the resilient wedge

Advantage of AVT EZ Valve

AVT AutoSet - Automated setup

Inspection started

inspection running Job Setup Completed

AutoSet saves you valuable setup time and costly resources, while ensuring high-quality results

Open the packing box and remove the three layers of foam packing

Remove the left inner side rail from the top packing layer. Remove the granite supporting rail from the middle packing layer. Remove the right inner side rail from the bottom packing layer.

Remove the accessories from their bag. This should include a hex key, fourteen M8x40 ſem eight by forty screws and four rubber grommets

Attach the bottom supporting rail to the inner side rails using two screws.

Fit the four rubber grommets onto the screws located at the top of the support rails for the granite.

Use the hex key to open the wooden box containing the granite slab, and remove the lid.

Place the granite slab on the top of the fourrubber grommets, making certain it is centered.

Remove the front supporting rail from the bottom packing layer. Take four screws and attach the rail to the front upper edge, using the two remaining screw holes on each of the side rails.

Remove the remaining rail from the top packing layer. Use two screws to attach the rail to the lower rear frame.

Congratulations on assembling your Anti-Vibration Table!

AVT EZ VALVE™ INSTALLATION PROCESS

MARK PIPE AND TAPE LOCATION OF VALVE GASKET

MOUNT ROTARY FEED DRIVE UNIT ON PIPE

MOUNT ALIGNMENT END RING

MOUNT END MILLING CUTTING MACHINE

VALVE BODY FILLED WITH WATER FOR TESTING NO NEED TO SHUT OFF WATER DURING CUTTING

BONNET MOUNTED ON CASTING

EZ VALVE GATE INSERTED 2/3 IN AND GASKET TIGHTENED

RESTRAINT BOLTS INSTALLED

OPEN WEDGE GATE

One Click to compare

Loading the Master & comparison

Results

Review the differences

The Structure of the Av2 Pro Certification

Subtitling English

Task Five Is a Subtitle Translation

Work Order Management Process

Work Order

Routing

Work Order Management

Gantt Chart

Work Order Scheduling

Forward Schedule

Schedule Forward

Location Filters

Assembly Build Process