動画検索
関連広告
検索結果
Introduction
Background
Upgrade No. 1: Klipper Backup
Upgrade No. 2: KIAUH
Upgrade No. 3: Mainsail
Upgrade No. 4: Custom Macros (Print Start, Print End, Load/Unload, Clean Nozzle, LEDs On/Off/Status, Take Snapshot)
Upgrade No. 5: Exclude Object
Upgrade No. 6: KAMP
Upgrade No. 7: Obcico / OctoEverywhere
Upgrade No. 8: Timelapse
Upgrade No. 9: gPhoto2 + GCode Shell Command (Optional)
Intro
Contents
T300 updating to v1.5.2
Backups
What to download & how to apply
Changes in v1.5.2
To-dos after the update
The problem with new adpative mesh
Fix A=make it work
Fix B=revert to pre-stored mesh
Fix C=best of both worlds: Christian Vick's KPA
Test print 1: CV's multi-mesh
Test print 2: CV's adaptive mesh
What's next?
Upgrade to Klipper on any Ender 3
Step 1 - Klipper, Moonraker & UI on Pi
Step 2 - Getting Started with Printer.cfg configuration file
Step 3 - Pi to control board connection. Hardware and software.
Step 4 - Completing and troubleshooting printer.cfg configuration
Step 5 - Tips and tricks for klipper, fluidd and mainsail
Step 6 - How to update Klipper
Step 7 - Subscribe & links below
welcome
what equipment
a little about klipper website
Flash the OS for klipper
PCBWay AD - Thank you PCBWay
flash is done, what's next
getting ready to Make the Firmware for the Controller (MCU)
UPDATE before making firmware!
understanding some expected errors when first booting
Now, Make the firmware... I talk too much I'm working on it
get the klipper.bin file off the host and onto an SD card
a good tip for if the firmware.bin is not flashing to the mcu
sd card with firmware.bin in mcu and power up
check that the board is communicating and get the serial ID
copy the the serial ID and where to place it
all done but what is this new error
DO NO DO THIS!! a demonstration of temps section to clear error