動画検索
関連広告
検索結果
Prep the Cable (1) Cut your length of cable and use masking tape to clearly mark the signal flow direction at each end The signal flow is clearly marked on the jacket
Cut the Cable (2) Give yourself approximately 1-1/4" of extra mesh from the 6" mark, cut through the mesh
(20) To remove the black inner jacket, untwist the 6 end of cable as best you can then use X-Acto to gently cut down the side. Peel off
Prep the Conductors (3) Heat the conductors slightly to make them easier to work with, then arrange them by separating
Feed solder into the socket, then insert the tinned red conductor. Repeat wtih black
Finishing Touches (4) Cut a red 5-1/4" piece of mesh for covering the conductors, burning the ends slightly with an iron to keep them from unravelling. Slide mesh over the red conductor. Position 1/2 x 1-1/2" piece of glue shrink so the end is approximately 1/2" from the edge of the jacket (6" mark).